CCDA 640-864 Q&As – WAN Technologies and Design (11-15)

February 27, 2012

Section 6 – WAN Technologies and Design

QUESTION 11
Which three types of WAN topologies can be deployed in the Cisco Enterprise Architecture Enterprise Edge WAN module? (Choose three.)
A.    ring
B.    full mesh
C.    partial mesh
D.    collapsed core
E.    star
F.    core
G.    edge
Answer: BCE

QUESTION 12
Which statement accurately describes one difference between a small office and medium office topology?
A.    Medium offices commonly use integrated route and switching platforms.
B.    Medium offices use integrated 10/100/1000 interfaces as Layer 2 trunks.
C.    Medium offices use external access switches to support LAN connectivity.
D.    Small offices commonly use Rapid PVST+ for Layer 3 deployments.
Answer: C
Explanation:
Medium Branch Design
The medium branch design is recommended for branch offices of 50 to 100 users, which is similar to the small branch but with an additional access router in the WAN edge (slightly larger) allowing for redundancy services. Typically, two 2921 or 2951 routers are used to support the WAN, and separate access switches are used to provide LAN connectivity.
The infrastructure components are dual-access routers, external Layer 2 / Layer 3 switches, laptops, desktops, printers, and IP phones. Dual Frame Relay links provide the private WAN services, which are used to connect back to the corporate offices via both of the access routers. Layer 3 protocols such as EIGRP are typically deployed. Because there are two routers, Hot Standby Router Protocol (HSRP) or Gateway Load Balancing Protocol (GLBP) can be used to provide redundancy gateway services. QoS can also be used to provide guaranteed bandwidth for VoIP, and policing can be used to restrict certain traffic classes from overwhelming the available bandwidth. Cisco IOS features such as QoS, access control lists (ACL), and RIP routing capabilities are available in the IP Base feature set, but IP unicast routing and multicast routing require the IP Services feature set.
The medium branch design supports using a higher-density external switch or using the EtherSwitch module with the ISR to create trunks to the external access switches. The Cisco Catalyst 3750 series switches have StackWise technology, allowing multiple switches to be connected and managed as one. This also increases the port density available for end-user connections. With Cisco StackWise technology, customers can create a single, 32-Gbps switching unit that can connect up to nine 3750 series switches using a variety of fiber and copper ports, allowing greater flexibility with the connection options.
Cisco Press CCDA 640-864 Official Certification Guide Fourth Edition, Chapter 7

QUESTION 13
Refer to the exhibit. All primary links are T1s. The customer wants to have a backup to each remote office from the Headquarters office.
Which two types of backup links would be viable solutions? (Choose two.)


A.    dial backup routing
B.    shadow SVC
C.    permanent secondary WAN link
D.    VPDN
Answer: AC

QUESTION 14
In the Cisco branch office design, what categorizes an office as large?
A.    between 50 and 100 users and a single-tier design
B.    between 100 and 200 users and a three-tier design
C.    between 50 and 100 users and a three-tier design
D.    over 200 users and a two-tier design
E.    between 100 and 200 users and a two-tier design
Answer: B

QUESTION 15
When designing using the Cisco Enterprise Architecture, in which Enterprise Campus layer do the Enterprise Edge and Enterprise WAN modules establish their connection?
A.    Building Access
B.    Building Distribution
C.    Campus Core
D.    Enterprise Branch
E.    Enterprise Data Center
Answer: C

 
Powered by Wordpress and MySQL. Theme by Shlomi Noach, openark.org